
These are the basic designs for the Paddle Boat.

showboat.pdf | |
File Size: | 4148 kb |
File Type: |
NEW HULL PLANS

Do not use a full scale print of this drawing. The drawing is done in autoCad and instead of redrawing it everytime I changed a measurement, I just changed the numbers and not the drawing scale. I changed the width some many times I can't remember what this drawing was originally at. But the measurements should be right. I'm planning on using them.
FRAMES

WHEELS PLANS

Here is the basic pattern for the paddle wheel. I plan to use 3/4" marine plywood for the hub and circle braces, and 2x4 for the paddle floats supports. The floats will be made of 2x8s. Need to make 4 since the chain drive is in the center of the axle with two identical paddle wheels on each side.
DOOR PLANS

PORT SIDE DRAWING

PORT SIDE INTERIOR PANELS

The space in the center of the wall is where the bathroom wall extends out.
PORT SIDE EXTERIOR PANELS

REAR SIDE CABIN FRAMING

REAR SIDE EXTERIOR PANELS

REAR SIDE INTERIOR PANELS

STARBOARD SIDE FRAMING

STARBOARD SIDE EXTERIOR PANELS

STARBOARD SIDE INTERIOR PANELS

Rudder Dimensions

Cut slits for a 1 1/4" pipe to be able to slide into. Then use resin putty to fill in the gaps and fair pipe into rudder to ease water flow.


main_wiring.bmp | |
File Size: | 202352 kb |
File Type: | bmp |